s/v Discovery

Finally, finally, finally!  We got the engine in. My buddy Keith was once again instrumental in loaning me his truck and some floor space in his company's huge warehouse were I could store the engine for a couple of weeks as I finished up the engine room.  I took the opportunity to level the Perkins on the nice smooth warehouse floor and take a bunch of measurements to make a jig that I used to locate the angle brackets for the engine mounts. yes, there was a final touch up coat of bilge paint to placate my OCD The aluminum angle is 1/2" thick, through bolted to the engine bearers.  Bolt holes were potted by drilling them oversize, filled with thickened epoxy, then the correct bolt hole size drilled, leaving a "sleeve" of epoxy contacting the bare wood(n o pictures of the potting procedure as they were on my iphone, which went swimming in the bilge and drowned).   If moisture is going to get to the solid wood stringers after all this, hopeful...

Been really busy juggling glassing in the engine bearers as well as all the other engine room projects, a steady parade of friends visiting, and some set dressing work in Hollywood.  Needless to say we're not as far along as hoped (surprise!)  Here are pics in the  (somewhat) order that these projects were done. Diaphragm bilge pump base assembly in need of some repair old hose fitting New hose barbs cut from a brass nipple and epoxied in old water heater good riddance found something in the manual bilge pump a paint marker, at least I know the pump can produce suction rotted deck on the left was torn out and replaced old bank. hoisted out the same way as the water heater nice crack new battery box, actually, there was no battery box at all previously plywood was glassed, box assembled, filleted with thickened resin, then corners tabbed and painted new bank hex bolts were c...